Topic: Need your help for TMIC stencil measurement

[BetaCuts]

Anyone have a factory IC with the STI on it?

I'm going to be making stencils so that you guys and gals can paint them.

I need the height and width of the original painted one.

Thanks

[energie]

Lemme go measure the one in my garage brb lol

[energie]

6 inch 9/16 for the width
18 inch 7/16 for length
For the rectangular opening of the top mount.
Both measurements are allowing a 1/16 inch clearance For the stencil to drop in.

The Sti logo is 9 inch 3/4 wide at the bottom and 3 inch 5/8 tall

Hope this is what you needed.

[LilDrunkenSmurf]

I still have the OEM intercooler with STi logo if you want to check it out.

[snackers]

In case this helps...

A= 18-1/2"
B= 6-3/4"
C= 3-1/16"
D= 1-1/2"
E= 12-1/8"
F= 4-5/8"

http://www.iwsti.com/forums/general/138102-intercooler-logo-measurements.html

There are lots of threads like this over there. Some of them probably even give you exact letter width and spacing too.

[Motohead]

Anyone have a factory IC with the STI on it?

I'm going to be making stencils so that you guys and gals can paint them.

I need the height and width of the original painted one.

Thanks

Sweet! Good on you!

Lemme go measure the one in my garage brb lol

Gotta stop skim reading, at first glance I thought you said "in my garbage". Was gonna jump up and down and say "yo, throw that itshay this way!"

LOL!

[energie]

Sweet! Good on you!


Gotta stop skim reading, at first glance I thought you said "in my garbage". Was gonna jump up and down and say "yo, throw that itshay this way!"

LOL!

Hahahah I'm selling it of your interested

[Motohead]

I'm good, but thanks for the offer bro!

[BetaCuts]

Damn you're good, thanks for posting this.
 
Anyways, I'll be selling stencils for $15 shipped or $13 picked up.
It will use paint mask vinyl which is lower tack and removeable once the painting has been done.

Unfortunately not re-useable, unless you're careful and can place the vinyl back onto the paper it came on without tearing things.

Brennan

In case this helps...


http://www.iwsti.com/forums/general/138102-intercooler-logo-measurements.html

There are lots of threads like this over there. Some of them probably even give you exact letter width and spacing too.