« previous next »
Pages: [1]   Go Down

Author Topic: cable to hyrdo slutch swap on second gen n/a  (Read 1460 times)

0 Members and 1 Guest are viewing this topic.

Offline vanszach

  • Stubbly Faced
  • **
  • Posts: 21
  • Location: Edmonton Alberta
  • Ride: '99 forester stb ej205
cable to hyrdo slutch swap on second gen n/a
« on: May 08, 2016, 11:22:52 pm »
|Hey everyone. so i have run into a transmission issue on my 98 Brighton 5mt. My input bearing is shot and i have a friend who has parts he says will fit but requires a hydro clutch but is still a push type. I'm wondering if anyone has ever attempted this and how hard it may be to do?? 
Logged

Offline RockThePylon

  • Rivaling ZZ-TOP
  • *****
  • Posts: 3586
  • Ghetto apostle
  • Location: Calgary
  • Ride: '03 WRX ricekar
Re: cable to hyrdo slutch swap on second gen n/a
« Reply #1 on: May 08, 2016, 11:40:49 pm »
You sure it's your input shaft bearing? How are you sure of this?

Are you using the right naming... Where exactly is this bearing?
Logged
I may scream like a dainty lady, but I punch like a fairly strong 11-year-old.

Offline vanszach

  • Stubbly Faced
  • **
  • Posts: 21
  • Location: Edmonton Alberta
  • Ride: '99 forester stb ej205
Re: cable to hyrdo slutch swap on second gen n/a
« Reply #2 on: May 09, 2016, 04:16:14 pm »
Im getting almost a rattle when the clutch is out, but when  push it in noise is gone. Just replaced clutch with oem kit, and a new clutch fork. Noise is still present.
Logged
Pages: [1]   Go Up
« previous next »