First. We worked on getting that dirty motheruckfayer of a cam bolt off. uckfay that piece of itshay.
What was tried -
10mm key which promptly stipped
11/16 extractor socket. Nope.
grinder to change the size of the bolt to fit a smaller extractor
big breaker bar and a snipe, as well as a powerful air impact
swearing at the bolt. didnt help
drilling the bolt center out to the point that there was virtually nothing holding on the cam gear.
trying to break the head off. nope.
hammering a 17mm socket on to the bolt.
.....it just spun out.
ok.
So then we removed stuff. And by we I mean Chase.
Its fine........ IMPOSSIBRLE!
Well now. theres the problem!!
What I want to know is. How is this even possible. its UNPOSSIBLE. how can you blow a hole in a valve without causing any damage anywhere else.
Good news is, the short block will be worth more.
Bad news is, Now my heads need new valves.