Where are the center caps for those BBSssssssssssssS?
Right here, bro.
Saw a good idea on the tubenetz, and fingered I'd try it out.
It mostly failed, but I learned some stuff that will make ver.2 much better.
Find 4 cans. Beer or some sort of soda will do. I happen to have some of these around.
Drink contents without opening the top.
Cut off the bottom, and wash them out.
Make the cap.
<imagine accurate and descriptive instructions placed here>
v.1
I didn't make the "legs" long enough, and putting the wheels on almost popped the top open as the axle shaft pushed into it.
v.1.1 (on the left) changed to account for this.
Make one to compliment each wheel on the car.
v.1 was modified to match v.1.1
Your choice on whether you leave it "au natural" or paint it some ungodly green.
I decided to do grimmspeed gold, since I have a bunch leftover.
Place on car.
Things I learned that will be changed for v.2:
Rear axles stick out further than front axles. Rear caps must be made deeper. I did not know this before I made all 4 caps the same depth to match the relatively shallow front axle stubs.
When cutting slices to account for making the can smaller (to match the 56.1 hub diameter) cut out a pie shape. Just slicing it makes overlap, which makes the wheel extremely tight on the hub, and makes install without damage difficult.
Painting is good, but... not really worth it. It just gets scraped off.